MG (SAIC) fault codes
7,311 codes · 85 vehicle records · 0 ECU records · 0 live-data parameters
Codes 7,311
| Code | Description | Brands | System |
|---|---|---|---|
| P0C7A | Drive motor 'B' inverter voltage too high | 25 | Powertrain |
| P0C7B | Generator inverter voltage too high | 22 | Powertrain |
| P0C7C | Hybrid Battery Temperature Sensor 'G' Circuit | 21 | Powertrain |
| P0C7D | Hybrid/EV Battery Temperature Sensor G Circuit Range/Performance | 26 | Powertrain |
| P0C7E | Hybrid Battery Temperature Sensor 'G' Circuit Low | 26 | Powertrain |
| P0C7F | Hybrid Battery Temperature Sensor 'G' Circuit High | 26 | Powertrain |
| P0C80 | High frequency receiver failure | 22 | Powertrain |
| P0C81 | Key transponder failure | 21 | Powertrain |
| P0C82 | Hybrid/EV Battery Temperature Sensor H Circuit Range/Performance | 26 | Powertrain |
| P0C83 | Transponder antenna failure | 26 | Powertrain |
| P0C84 | Transponder tag reading failure | 26 | Powertrain |
| P0C85 | Lighting control failure | 22 | Powertrain |
| P0C86 | Faulty button at the bottom of the lighting control lever | 19 | Powertrain |
| P0C87 | The button at the bottom of the wiper control lever is faulty | 19 | Powertrain |
| P0D11 | Right side lock opening actuator failure | 23 | Powertrain |
| P0FFF | Time Reference High Res Signal A Erratic Pulses | 17 | Powertrain |
| P1000 | OBD-II Monitor Testing Incomplete | 33 | Powertrain |
| P1001 | Short circuit to positive | 32 | Powertrain |
| P1106 | Manifold Absolute Pressure Sensor Circuit Intermittent Low Voltage | 31 | Powertrain |
| P1107 | Manifold Absolute Pressure Sensor Circuit Intermittent High Voltage | 30 | Powertrain |
| P1108 | Intake air pressure sensor circuit voltage high intermittently | 27 | Powertrain |
| P1109 | The intake air pressure sensor signal is implausible when the engine is running | 27 | Powertrain |
| P1111 | Supercharged intake air temperature (IAT) sensor signal is implausible (high) | 32 | Powertrain |
| P1112 | Short circuit to negative | 28 | Powertrain |
| P1185 | DME: ACAT sensor, signal after SA, implausible, bank 2 | 23 | Powertrain |
| P1186 | DME: Heat output, ox.sensor after cat.conv., bank 1 | 25 | Powertrain |
| P1191 | Key line voltage | 31 | Powertrain |
| P1192 | too great in lean range | 33 | Powertrain |
| P1200 | Fuel injector open circuit | 30 | Powertrain |
| P1201 | Cylinder 1 injector | 32 | Powertrain |
| P1203 | Cylinder 3 injector | 30 | Powertrain |
| P1215 | Pedal position sensor C circuit low input | 28 | Powertrain |
| P1231 | Cylinder 7 fuel injection circuit short to ground | 26 | Powertrain |
| P1232 | Pressure regulator | 28 | Powertrain |
| P1237 | Boost pressure sensor circuit voltage low intermittently | 31 | Powertrain |
| P1238 | Boost pressure sensor circuit voltage high intermittently | 32 | Powertrain |
| P1239 | Fuel injector for cylinder 3 (N32): open circuit | 32 | Powertrain |
| P1240 | Cylinder 4 fuel injection circuit open | 28 | Powertrain |
| P1241 | Fuel Injector for Cylinder 5 (N83): Open Circuit | 28 | Powertrain |
| P1242 | Fuel Injector for Cylinder 6 (N84): Open Circuit | 29 | Powertrain |
| P1286 | Fuel injection air control valve circuit short to battery (+) | 29 | Powertrain |
| P1290 | Cold start fuel pressure too high (bank 1) | 26 | Powertrain |
| P1297 | Pressure drop between turbo and throttle valve (check D.V.!) | 29 | Powertrain |
| P1300 | Boost calibration fault | 35 | Powertrain |
| P130A | Cylinder disabling; Defective | 17 | Powertrain |
| P1316 | Injector circuit/IDM codes detected | 20 | Powertrain |
| P1336 | Engine torque monitor: control limit exceeded; Open circuit | 33 | Powertrain |
| P1379 | Fuel injector control module system voltage high | 18 | Powertrain |
| P1386 | Knock-evaluation circuit faulty | 30 | Powertrain |
| P1427 | EGR temperature sensor 1 - intake air temperature 1 not plausible | 25 | Powertrain |
Some brand data is extracted from diagnostic files and may contain manufacturer-specific wording. General SAE J2012 descriptions are used where available.