Maserati fault codes
3,188 codes · 55 vehicle records · 106 ECU records · 0 live-data parameters
Codes 3,188
| Code | Description | Brands | System |
|---|---|---|---|
| C15CC | Rear axle tire pressure placard value implausible | 1 | Chassis |
| C15D0 | Acceleration Sensor Supply | 7 | Chassis |
| C15D1 | Left Front Wheel Acceleration Sensor-Signal Rate of Change Below Threshold | 8 | Chassis |
| C15D2 | Right Front Wheel Acceleration Sensor-Signal Rate of Change Below Threshold | 8 | Chassis |
| C15D3 | Left front damping valve solenoid circuit short to battery | 2 | Chassis |
| C15D4 | Right front damping valve solenoid circuit short to battery | 7 | Chassis |
| C15D5 | Left rear damping valve solenoid circuit short to battery | 8 | Chassis |
| C15D6 | Run Flat Tire Pressure Below Threshold | 8 | Chassis |
| C15D7 | Right rear damping valve solenoid circuit short to battery | 8 | Chassis |
| C15D8 | Mismatch tire size | 8 | Chassis |
| C15D9 | Low air mass | 7 | Chassis |
| C15DA | Payload limit exceeded | 8 | Chassis |
| C1607 | Diag C I B U S C M T O | 26 | Chassis |
| C1622 | Battery voltage too low | 14 | Chassis |
| C1800 | The 4WAS/2WAS Module shall log DTC when it determines that a fault exists in the output circuit for the relay that controls air flow to and from the Reservoir | 11 | Chassis |
| C1802 | PBC signal fault | 11 | Chassis |
| C1881 | No description available | 3 | Chassis |
| C2100 | Battery voltage low - circuit voltage below threshold | 10 | Chassis |
| C2101 | Outside air temperature sensor abnormal | 16 | Chassis |
| C2104 | Anti-Lock Brake System/Electronic System Controller Valve Supply Voltage-Performance or Incorrect Operation | 7 | Chassis |
| C210C | Supply Voltage Circuit Voltage Below Threshold | 2 | Chassis |
| C2110 | Sensor supply 1 voltage circuit short to battery | 3 | Chassis |
| C211B | 2E0A00 2E0B00 00 02 02 000000 00 ignition run/start input circuit performance | 3 | Chassis |
| C2125 | Sensor supply 2 voltage circuit short to battery | 4 | Chassis |
| C2128 | ECU Reset/Recovery Occurred | 5 | Chassis |
| C2129 | Battery voltage - circuit voltage below threshold | 1 | Chassis |
| C212A | System Voltage Circuit Voltage Below Threshold | 1 | Chassis |
| C212B | Sensor supply 3 voltage circuit short to battery | 1 | Chassis |
| C212C | Suspension valve power supply voltage circuit short to battery | 1 | Chassis |
| C2200 | Engine oil level too low | 11 | Chassis |
| C2202 | If C2206, C123A, and/or are active then continue, else if any other ABS DTCs are active correct those first before continuing | 4 | Chassis |
| C2205 | Steering Angle Sensor Internal-Component Internal Failure | 6 | Chassis |
| C2206 | Vehicle configuration mismatch | 11 | Chassis |
| C2209 | Tire Pressure Monitor Internal | 5 | Chassis |
| C220C | Active Suspension Module Internal-Internal Electronic Failure | 1 | Chassis |
| C2210 | ECU overtemperature | 3 | Chassis |
| C2212 | ECU in - plant mode | 4 | Chassis |
| C2217 | Electric Power Steering (EPS) module internal | 3 | Chassis |
| C2219 | ECU Unable To Configure/Configuration Not Learned | 2 | Chassis |
| C221C | ECU flash required - missing calibration | 1 | Chassis |
| C2223 | ECU Configuration Mismatch | 5 | Chassis |
| C2224 | Classification Not Learned | 5 | Chassis |
| C2225 | ECU with PCM disabled | 4 | Chassis |
| C2226 | Transmission Control Module (TCM) disabled ECU | 4 | Chassis |
| C2227 | Brake pad temperature too high | 7 | Chassis |
| C2318 | Front camera mounting position wrong | 5 | Chassis |
| C25200 | Lost communication with trailer lighting module | 1 | Chassis |
| C40500 | Invalid data received from cruise control module | 1 | Chassis |
| C42088 | Invalid data received From Power Steering Control (PSC) module bus off | 1 | Chassis |
| C42100 | Implausible data received from suspension control module | 1 | Chassis |
Some brand data is extracted from diagnostic files and may contain manufacturer-specific wording. General SAE J2012 descriptions are used where available.