SsangYong fault codes
4,752 codes · 93 vehicle records · 0 ECU records · 0 live-data parameters
Codes 4,752
| Code | Description | Brands | System |
|---|---|---|---|
| P115964 | AC/DC charge plug lock signal error | 2 | Powertrain |
| P116007 | AC/DC charge plug lock not working | 2 | Powertrain |
| P116102 | AC charge plug overheating | 1 | Powertrain |
| P116202 | DC charge plug temperature signal error | 1 | Powertrain |
| P116301 | AC/DC charge plug lock error | 1 | Powertrain |
| P116411 | AC/DC charge plug lock L circuit short to ground | 1 | Powertrain |
| P116513 | AC/DC charge plug lock circuit open | 1 | Powertrain |
| P116601 | Status of AC/DC charge plug lock L | 1 | Powertrain |
| P116712 | AC/DC charge plug lock R circuit short to battery | 1 | Powertrain |
| P116811 | AC/DC charge plug lock R circuit short to ground | 1 | Powertrain |
| P116913 | AC/DC charge plug lock R circuit open | 1 | Powertrain |
| P117000 | Torque trim fault - high | 1 | Powertrain |
| P117001 | Status of AC/DC charge plug lock R | 1 | Powertrain |
| P117100 | Defekfehlercode für Nebenschlusserkennung der Lambdasonde | 3 | Powertrain |
| P11711C | Charging door open | 1 | Powertrain |
| P117200 | Lambdasonde nach OxiKat Diagnoseleitung Referenzpumpstrom,O2 Spannung Bereichsgrenze verletzt (Bank 1)- nicht verbaut | 3 | Powertrain |
| P117204 | Charge impossible (on-board charger error) | 1 | Powertrain |
| P117300 | 3 injector MDP malfunction | 2 | Powertrain |
| P117312 | Control pilot circuit short to battery (+) | 1 | Powertrain |
| P117400 | 4 injector MDP malfunction | 1 | Powertrain |
| P117414 | Control pilot circuit open or short to ground | 1 | Powertrain |
| P117500 | 5 injector MDP malfunction | 1 | Powertrain |
| P117504 | On-Board Charger (OBC) charge speed low | 1 | Powertrain |
| P117604 | On-Board Charger (OBC) not working | 2 | Powertrain |
| P117711 | Cruise control signal circuit short to ground or stuck off | 1 | Powertrain |
| P117812 | Cruise control signal circuit short to battery (+) or stuck on | 1 | Powertrain |
| P117902 | Main contactor off request detected (interlock error) | 1 | Powertrain |
| P118093 | IGN3 operation failure | 1 | Powertrain |
| P118193 | IGN4 operation failure | 2 | Powertrain |
| P118292 | Fast charging relay failure | 1 | Powertrain |
| P118348 | ECU not coded (no data entered) | 1 | Powertrain |
| P118448 | No Immbilizer response | 1 | Powertrain |
| P118548 | Immobilizer signal error | 1 | Powertrain |
| P118629 | Brake Safety Control (BSC) signal error | 1 | Powertrain |
| P11874B | Coolant temperature high (overheating) | 1 | Powertrain |
| P118862 | 12 V system voltage instability | 1 | Powertrain |
| P118962 | Brake pedal position - switch signal mismatch | 1 | Powertrain |
| P119000 | Rail pressure is over a positive threshold during the last consecutive key on (sensor drift detection) | 1 | Powertrain |
| P119012 | Charging door open/close switch, PIN AE2 circuit short to battery | 3 | Powertrain |
| P119100 | The pressure does not reach the demand after a calibrated time during starting (filling rail state) | 2 | Powertrain |
| P119111 | Charging door open/close switch, PIN AE2 circuit short to ground | 1 | Powertrain |
| P119200 | Rail pressure at key on is under a negative threshold (not physically feasible) | 1 | Powertrain |
| P119213 | Charging door open/close switch, PIN AE2 circuit open | 1 | Powertrain |
| P119300 | Rail pressure at key on as increased more than a calibrated threshold since the last power latch | 1 | Powertrain |
| P119312 | Charging door open relay CG4 circuit short to battery (+) | 1 | Powertrain |
| P119313 | Charging door open relay PIN CG4 circuit open or short to ground | 2 | Powertrain |
| P119414 | Charging door open relay CG4 circuit open | 1 | Powertrain |
| P119621 | AC charging CP voltage error | 1 | Powertrain |
| P119721 | DC charging CP voltage error | 1 | Powertrain |
| P119803 | AC charging CP frequency error | 1 | Powertrain |
Some brand data is extracted from diagnostic files and may contain manufacturer-specific wording. General SAE J2012 descriptions are used where available.