Great Wall fault codes
5,858 codes · 56 vehicle records · 0 ECU records · 0 live-data parameters
Codes 5,858
| Code | Description | Brands | System |
|---|---|---|---|
| P1253 | VSV Stuck on VR | 26 | Powertrain |
| P1254 | Fuel consumption signal Short to B+ | 24 | Powertrain |
| P1255 | Fuel pump control module driver high temperature | 27 | Powertrain |
| P1256 | Contactor forced disconnection | 29 | Powertrain |
| P1257 | Supercharge Engine Over Boost | 21 | Powertrain |
| P1258 | Alarm signal error | 24 | Powertrain |
| P1259 | Electronic stability control (ESC) master cylinder pressure signal is invalid | 25 | Powertrain |
| P125A | Fuel pressure regulator 2 high control circuit low voltage | 12 | Powertrain |
| P125B | Vapor Bubble Formation in low-pressure fuel circuit; Short to ground | 12 | Powertrain |
| P1260 | Theft Detected - Engine Disabled | 23 | Powertrain |
| P1264 | Rise time is lower than the threshold (cylinder 2) | 24 | Powertrain |
| P1265 | Cylinder 5 high to low side is short | 23 | Powertrain |
| P1266 | Injector 3 - implausible signal | 22 | Powertrain |
| P1267 | PD Unit Injector: Cylinder 3 (N242): Regulation Range Exceeded | 23 | Powertrain |
| P1268 | Injector 1 | 21 | Powertrain |
| P1269 | PD Unit Injector: Cylinder 4 (N243): Implausible Signal | 18 | Powertrain |
| P126A | Cylinder 1 Injector Input Circuit | 13 | Powertrain |
| P1272 | Accelerator pedal position sensor 2-3 correlation | 25 | Powertrain |
| P1273 | Accelerator pedal position sensor 1-3 correlation | 25 | Powertrain |
| P1274 | A/F sensor 1 (bank 1) | 23 | Powertrain |
| P1275 | Accelerator Pedal Pos Sens1 Circ | 26 | Powertrain |
| P1278 | Cold start fuel pump | 23 | Powertrain |
| P1280 | ICP Circ Out of Range Low | 17 | Powertrain |
| P1286 | Fuel injection air control valve circuit short to battery (+) | 29 | Powertrain |
| P1287 | Turbocharger bypass valve open | 25 | Powertrain |
| P1288 | Cylinder head temperature sensor out of self-test range | 24 | Powertrain |
| P1289 | Turbocharger bypass valve short to ground | 24 | Powertrain |
| P1296 | Error in Mapped Cooling System | 20 | Powertrain |
| P1297 | Pressure drop between turbo and throttle valve (check D.V.!) | 29 | Powertrain |
| P1298 | Injector driver module failure | 16 | Powertrain |
| P1299 | Cylinder Head Over Temperature Protection Active | 18 | Powertrain |
| P12FF | Cylinder deactivation exhaust flow control valve performance bank 2 | 11 | Powertrain |
| P1300 | Boost calibration fault | 35 | Powertrain |
| P1301 | Boost calibration high | 34 | Powertrain |
| P1313 | Misfire Cylinder 1 Emission Related | 20 | Powertrain |
| P1333 | Knock sensor 4 high input | 19 | Powertrain |
| P1335 | Crankshaft position sensor (reference) | 34 | Powertrain |
| P1336 | Engine torque monitor: control limit exceeded; Open circuit | 33 | Powertrain |
| P1338 | Cylinder 2 misfire | 22 | Powertrain |
| P1340 | Cylinder 4 misfire | 30 | Powertrain |
| P1343 | Misfiring with cylinder cutout | 22 | Powertrain |
| P1380 | Camshaft Position Actuator Circ | 21 | Powertrain |
| P1381 | Knock-evaluation circuit faulty | 22 | Powertrain |
| P1382 | Knock-evaluation circuit faulty | 25 | Powertrain |
| P1387 | Control module malfunction - internal Altitude/pressure sensor; Defective | 19 | Powertrain |
| P1391 | Intermittent Loss of CMP or CKP | 27 | Powertrain |
| P1392 | Camshaft position sensor, bank 2 open circuit/short to battery (+) | 23 | Powertrain |
| P1393 | Ignition coil power output stage 1 electrical malfunction | 23 | Powertrain |
| P1396 | Glow Plug Monitor Fault | 20 | Powertrain |
| P1397 | DME: Signal, exhaust-camshaft sensor | 24 | Powertrain |
Some brand data is extracted from diagnostic files and may contain manufacturer-specific wording. General SAE J2012 descriptions are used where available.