Suzuki fault codes
5,947 codes · 72 vehicle records · 65 ECU records · 0 live-data parameters
Codes 5,947
| Code | Description | Brands | System |
|---|---|---|---|
| C11A6 | Invalid Auto Brake Request Received from Stereo Camera Module | 7 | Chassis |
| C11A9 | MFL Request Failure | 7 | Chassis |
| C11AC | Invalid Auto Brake request received from Sonar Control Module | 7 | Chassis |
| C11B0 | Left motor circuit open or faulty | 10 | Chassis |
| C11C0 | Electronic Parking Brake (EPB) gradient sensor not calibrated | 4 | Chassis |
| C11C1 | No description available | 1 | Chassis |
| C11D0 | No description available | 1 | Chassis |
| C11D1 | Demand lamp - circuit short to high | 5 | Chassis |
| C11D2 | No description available | 9 | Chassis |
| C11D3 | No description available | 3 | Chassis |
| C11D4 | No description available | 4 | Chassis |
| C11D5 | No description available | 3 | Chassis |
| C11D6 | No description available | 3 | Chassis |
| C11D7 | No description available | 3 | Chassis |
| C11F0 | No description available | 7 | Chassis |
| C11F1 | No description available | 7 | Chassis |
| C11F2 | No description available | 1 | Chassis |
| C11F3 | No description available | 9 | Chassis |
| C11F4 | 53 detected | 1 | Chassis |
| C1200 | Torque sensor power supply voltage failure | 30 | Chassis |
| C1201 | Motor circuit short to battery or ground | 30 | Chassis |
| C1202 | Current following abnormality | 29 | Chassis |
| C1203 | Current is too large | 24 | Chassis |
| C1204 | Motor current too low | 24 | Chassis |
| C1205 | Power supply voltage too high | 29 | Chassis |
| C1206 | Power supply voltage too low | 28 | Chassis |
| C120A | Ignition signal lost | 11 | Chassis |
| C120C | Torque sensor power supply is seriously abnormal | 15 | Chassis |
| C120E | Steering angle not initialized | 9 | Chassis |
| C120F | Steering angle not calibrated | 12 | Chassis |
| C1210 | Fault - engine in running status | 29 | Chassis |
| C1211 | Attempt to restart assist at high speed | 29 | Chassis |
| C1212 | Vehicle speed signal not received | 26 | Chassis |
| C1213 | Seat squab adjustment switch - passenger's | 20 | Chassis |
| C1214 | C1215 Memory switch position 1/2 - passenger's | 14 | Chassis |
| C1215 | C1214/ Memory switch position 1/2 - passenger's | 21 | Chassis |
| C1216 | Memory switch position 3 - passenger's | 22 | Chassis |
| C1217 | Pump motor shorted to ground | 21 | Chassis |
| C1218 | Massage switch - passenger's | 16 | Chassis |
| C121F | If CAN signals are not entered from the door module at the passenger's seat that controls the side mirror (indicator) in the passenger's seat, BSD ECU sets DTC and turns off BSD switch LED and inhibits system operation | 11 | Chassis |
| C1220 | Seat squab heater - front passenger's | 15 | Chassis |
| C1221 | Seat squab temperature sensor - passenger's | 21 | Chassis |
| C1222 | Seat depth motor - passenger's | 26 | Chassis |
| C1223 | Seat depth sensor - passenger's | 22 | Chassis |
| C1224 | Seat tilt motor - passenger's | 16 | Chassis |
| C1225 | Speed control relay - passenger's | 25 | Chassis |
| C1226 | Excessive RF Wheel Acceleration | 25 | Chassis |
| C1227 | Seat lumbar support/massage CM - passenger's | 16 | Chassis |
| C1228 | Excessive RR Wheel Acceleration | 15 | Chassis |
| C1229 | Torque and angle signal power supply failure | 12 | Chassis |
Some brand data is extracted from diagnostic files and may contain manufacturer-specific wording. General SAE J2012 descriptions are used where available.