SsangYong fault codes
4,752 codes · 93 vehicle records · 0 ECU records · 0 live-data parameters
Codes 4,752
| Code | Description | Brands | System |
|---|---|---|---|
| B121119 | Driver Knee Airbag - Cross Connect | 2 | Body |
| B121200 | If abnormal Front Center Right Sensor operation signal is detected, BCM sets DTC | 2 | Body |
| B121207 | Der Stellmotor für Luftverteilungsklappe vorn links hat Funktionsstörung. Es liegt ein mechanischer Fehler vor. | 2 | Body |
| B121300 | If abnormal Front Right Sensor operation signal is detected, BCM sets DTC | 3 | Body |
| B121307 | Closing fault | 1 | Body |
| B121411 | B_CAN limp home | 1 | Body |
| B121588 | B_CAN bus off | 1 | Body |
| B12161D | BCAN single line fault | 1 | Body |
| B125800 | Faulty slide motor operation detection | 1 | Body |
| B125900 | Over current in slide motor | 1 | Body |
| B125A00 | Faulty recliner motor operation detection | 1 | Body |
| B125B00 | Over current in recliner motor | 1 | Body |
| B125C00 | Faulty ventilation motor | 1 | Body |
| B125D00 | Faulty seat heater | 1 | Body |
| B125E00 | Faulty seat heater sensor | 1 | Body |
| B125F00 | CAN: emergency mode (limp home) | 1 | Body |
| B126000 | CAN: communication interruption(bus off) | 1 | Body |
| B128500 | Front Camera Signal Error | 1 | Body |
| B128600 | Rear Camera Signal Error | 1 | Body |
| B128700 | Left Camera Signal Error | 1 | Body |
| B128800 | Right Camera Signal Error | 1 | Body |
| B12BC00 | Over current in LH seat slide motor | 1 | Body |
| B12BD00 | Over current in RH seat slide motor | 1 | Body |
| B12BE00 | Over current in leg support tilt motor | 1 | Body |
| B12BF00 | Over current in leg support slide motor | 1 | Body |
| B12C000 | Faulty RR LH seat ventilation motor | 1 | Body |
| B12C100 | Faulty RR RH seat ventilation motor | 1 | Body |
| B12C200 | Faulty RR LH seat heater | 1 | Body |
| B12C300 | Faulty RR LH seat heater sensor | 1 | Body |
| B12C400 | Faulty RR RH seat heater | 1 | Body |
| B12C500 | Faulty RR RH seat heater sensor | 1 | Body |
| B12C600 | CAN: emergency mode (limp home) | 1 | Body |
| B12C700 | CAN: communication interruption(bus off) | 1 | Body |
| B130000 | CAN invalid data (CAN detected) | 1 | Body |
| B130100 | Immo coil failure | 2 | Body |
| B130200 | Open circuit in wiper on/off circuit | 1 | Body |
| B130300 | Overloaded wiper on/off circuit | 1 | Body |
| B130400 | Open circuit in wiper high/low circuit | 1 | Body |
| B130500 | Overloaded wiper high/low circuit | 1 | Body |
| B130600 | Open circuit in tail lamp circuit | 1 | Body |
| B130700 | Overloaded tail lamp circuit | 1 | Body |
| B130800 | Open circuit in fog lamp circuit | 1 | Body |
| B130900 | Start inhibit active | 2 | Body |
| B130A00 | Open circuit in FRT windshield defogger circuit | 1 | Body |
| B130B00 | Overloaded FRT windshield defogger circuit | 1 | Body |
| B130C00 | Open circuit in FRT windshield washer circuit | 1 | Body |
| B130D00 | Overloaded FRT windshield washer circuit | 1 | Body |
| B130E00 | Open circuit in headlamp washer circuit | 1 | Body |
| B130F00 | Overloaded headlamp washer circuit | 1 | Body |
| B131000 | Open circuit in headlamp low circuit | 2 | Body |
Some brand data is extracted from diagnostic files and may contain manufacturer-specific wording. General SAE J2012 descriptions are used where available.