SsangYong fault codes
4,752 codes · 93 vehicle records · 0 ECU records · 0 live-data parameters
Codes 4,752
| Code | Description | Brands | System |
|---|---|---|---|
| B161800 | Service alignment elevation failed - sensor boresight is too low | 1 | Body |
| B161900 | Service alignment elevation failed - sensor boresight is too high | 1 | Body |
| B161A00 | If internal error of SVMS ECU is detected, SVMS ECU sets DTC | 2 | Body |
| B161B00 | Service alignment elevation failed - azimuth adjustment request time out | 1 | Body |
| B161C00 | is set when ADM('PASSENGER DOOR MODULE') is not received LIN data from 'SMART CONNECTOR' in the passenger power outside mirror | 2 | Body |
| B161D00 | Service alignment elevation failed - sparse target data | 1 | Body |
| B161E00 | Service alignment azimuth failed - sparse target data | 1 | Body |
| B161F00 | Die Taste 'SOS' klemmt. | 2 | Body |
| B162000 | Die Taste 'MB-Info-Ruf' klemmt. | 3 | Body |
| B162100 | Die Taste 'Pannenruf' klemmt. | 3 | Body |
| B162200 | No description available | 1 | Body |
| B162300 | If channel DC level too high | 1 | Body |
| B162400 | VCO start frequency too low | 1 | Body |
| B162500 | VCO end frequency too high | 1 | Body |
| B162600 | VCO frequency slope too low | 1 | Body |
| B162700 | Tx-Center frequency wrong | 1 | Body |
| B162800 | Slope of the frequency chirp wrong | 1 | Body |
| B162900 | If abnormal LIN Data of Front & Rear Sensor operation signal is detected, BCM sets DTC | 2 | Body |
| B162A00 | is set when LIN data from WMM is not transmitted to 'BCM' caused by the LIN communication line/the ultrasonic sensor fault or LIN data is abnormal | 2 | Body |
| B162B00 | Prescaler VCO-path permanently enabled | 1 | Body |
| B162C00 | If a camera output signal is not received at the SVM ECU, DTC will set.A Blue Screen on the Headunit display screen indicates an error in camera output | 2 | Body |
| B164900 | If rollover crash data is stored in SRSCM, SRSCM sets DTC.If the DTC B164900 'Crash recorded - Rollover event(Replace ECU)' is set, replace the SRSCM | 2 | Body |
| B165000 | Navigation Compatibility Error - Navigation-Software is not compatible with Command software | 3 | Body |
| B165100 | Update Map Data - Map data are not compatible with the navigation software. | 3 | Body |
| B165200 | The SRSCM sets DTC if PSAB and PCAB deploys | 2 | Body |
| B165500 | System calibration required | 1 | Body |
| B165700 | The SRSCM sets DTC if any BPT deploys | 2 | Body |
| B165900 | Rear Crash Detected | 1 | Body |
| B167000 | The SRSCM sets DTC if Crash recorded in full stage in the SRS Control module | 2 | Body |
| B167600 | The SRSCM sets DTC if DAB,PAB and DSAB deploys | 2 | Body |
| B167700 | Front crash record (passenger side/curtain airbag deployed) | 1 | Body |
| B167800 | If airbag is deployed by the Scrap tool, SRSCM sets DTC | 2 | Body |
| B168300 | If ACU coding error exceed 255 times, SRSCM sets DTC | 2 | Body |
| B168400 | If ACU configuration is different with vehicle configuration, SRSCM sets DTC | 2 | Body |
| B170000 | Motor azimuth hardware failures | 1 | Body |
| B170100 | Driver seat buckle pretensioner circuit resistance high | 1 | Body |
| B170200 | Driver seat buckle pretensioner circuit resistance low | 1 | Body |
| B170300 | Driver seat buckle pretensioner circuit short to ground | 1 | Body |
| B170400 | Driver seat buckle pretensioner circuit short to battery (+) | 1 | Body |
| B170600 | Passenger seat buckle pretensioner circuit resistance high | 1 | Body |
| B170700 | Passenger seat buckle pretensioner circuit resistance low | 1 | Body |
| B170800 | Passenger seat buckle pretensioner circuit short to ground | 1 | Body |
| B170900 | Passenger seat buckle pretensioner circuit short to battery (+) | 1 | Body |
| B171100 | The SRSCM sets DTC if the measured resistance value of DAB circuit is more than the threshold value.*In this case, SRSCM checks if there's any fault in circuit by sending current for a while | 2 | Body |
| B171200 | The SRSCM sets DTC if the measured resistance value of KAB circuit is less than the threshold value.*In this case, SRSCM checks if there's any fault in circuit by sending current for a while | 2 | Body |
| B171300 | The SRSCM sets DTC if there is a short to ground in KAB harness*In this case, SRSCM checks if there's any fault in circuit by sending current for a while | 2 | Body |
| B171400 | The SRSCM sets DTC if there is a short to power in KAB harness*In this case, SRSCM checks if there's any fault in circuit by sending current for a while | 2 | Body |
| B171500 | High passenger knee air bag resistance | 1 | Body |
| B171600 | Low passenger knee air bag resistance | 1 | Body |
| B171700 | Short circuit to ground in passenger knee air bag | 1 | Body |
Some brand data is extracted from diagnostic files and may contain manufacturer-specific wording. General SAE J2012 descriptions are used where available.