Sprinter fault codes
4,904 codes · 824 vehicle records · 187 ECU records · 19,551 live-data parameters
Codes 4,904
| Code | Description | Brands | System |
|---|---|---|---|
| C000301 | Steuergerät Ventil MCI2 elektrischer Fehler - Allgemeiner elektrischer Fehler | 3 | Chassis |
| C000400 | OBD relevant DTC in RBS. For detailed information read Fault Memory of RBS | 2 | Chassis |
| C000401 | Steuergerät Ventil LPF2 elektrischer Fehler - Allgemeiner elektrischer Fehler | 3 | Chassis |
| C000500 | No description available | 2 | Chassis |
| C001001 | Steuergerät Ventil EVVL elektrischer Fehler - Allgemeiner elektrischer Fehler | 2 | Chassis |
| C003100 | DFA configuration in System IC does not fit to software configuration. | 2 | Chassis |
| C003400 | The right front wheel speed sensor has a malfunction. | 2 | Chassis |
| C006C64 | Stability System | 2 | Chassis |
| C054600 | VIN Not Programmed or Incompatible | 2 | Chassis |
| C0D00 | No description available | 2 | Chassis |
| C1000 | Hill descent control function | 24 | Chassis |
| C1001 | Tandem brake master cylinder, pressure: Plausibility | 22 | Chassis |
| C100100 | Body acceleration sensor front left short to ground | 3 | Chassis |
| C1002 | RF of left rear TPMS communication failure | 17 | Chassis |
| C100200 | Body acceleration sensor front left short to battery or open | 3 | Chassis |
| C1004 | ABS operation fault | 19 | Chassis |
| C1005 | Torque sensor power voltage failure (in usual condition) | 20 | Chassis |
| C1007 | Diag C I B U S C M T O | 20 | Chassis |
| C100981 | No description available | 2 | Chassis |
| C1010 | Tandem brake master cylinder, pressure sensor 1: Signal offset | 22 | Chassis |
| C1011 | Tandem brake master cylinder, pressure sensor 2: Signal offset | 21 | Chassis |
| C1012 | Tandem brake master cylinder, pressure sensor 1: General electrical fault | 22 | Chassis |
| C1020 | Diaphragm travel sensor: Signal faulty | 16 | Chassis |
| C1021 | ECU internal fault (temperature sensor system) | 23 | Chassis |
| C1022 | Boot/Trunk Secondary Switch | 17 | Chassis |
| C1023 | Pull Drift Compensation Limit Exceeded | 13 | Chassis |
| C1024 | System temporarily disabled due to power interruption during driving | 11 | Chassis |
| C1026 | ABS Secondary Circuit Over Boost Pressure | 13 | Chassis |
| C1030 | Low-pressure sensor, signal 1: Electrical fault | 13 | Chassis |
| C1032 | Low-pressure sensor, plausibility | 19 | Chassis |
| C1038 | Front left - Damper drive | 8 | Chassis |
| C1040 | Electric vacuum pump: Voltage on feedback line too low | 16 | Chassis |
| C1041 | 00 ayarlandı | 16 | Chassis |
| C1042 | Pump motor open fault | 17 | Chassis |
| C1050 | Shutoff valve, pressure sensor: Electrical fault | 17 | Chassis |
| C1051 | Shutoff valve: Electrical fault | 15 | Chassis |
| C1054 | System functionality reduced by diagnostic request | 13 | Chassis |
| C1055 | Electronic Control Unit (ECU) Performance | 14 | Chassis |
| C1056 | Air Suspension -66 | 13 | Chassis |
| C1057 | System relay coil short to ground | 13 | Chassis |
| C105A00 | No description available | 2 | Chassis |
| C1060 | ECO switch | 7 | Chassis |
| C1061 | Brake disc wear | 12 | Chassis |
| C1070 | Brake pedal travel sensor: Adjustment faulty | 15 | Chassis |
| C1071 | Hybrid master control unit (HCP) interface: Signal invalid | 12 | Chassis |
| C1072 | DSC interface: Signal invalid | 16 | Chassis |
| C1080 | Hybrid brake actuation changeover (SBA): Undervoltage | 9 | Chassis |
| C1081 | Hybrid brake actuation changeover (SBA): Overvoltage | 12 | Chassis |
| C1082 | Hybrid brake actuation changeover (SBA) control unit, internal | 15 | Chassis |
| C1084 | Left Front outlet valve failure | 6 | Chassis |
Some brand data is extracted from diagnostic files and may contain manufacturer-specific wording. General SAE J2012 descriptions are used where available.