MG (SAIC) fault codes
7,311 codes · 85 vehicle records · 0 ECU records · 0 live-data parameters
Codes 7,311
| Code | Description | Brands | System |
|---|---|---|---|
| B1A48 | Primary/auxiliary radar self-calibration error - no such type of fault information | 6 | Body |
| B1A49 | Defrost Switch Stuck | 4 | Body |
| B1A4A | Door Mirror Mounted Maneuvering Lamp - Short Circuit To Ground | 3 | Body |
| B1A4B | Custom Switch (SWC) Stuck | 2 | Body |
| B1A4C | 'Car' Switch Stuck | 2 | Body |
| B1A4D | 'Music' keycard key | 2 | Body |
| B1A4E | 'Music' or '360'Switch Stuck | 2 | Body |
| B1A4F | 'Climate' Switch Stuck | 2 | Body |
| B1A50 | Driver's mirror switch pack failure | 3 | Body |
| B1A51 | Driver's seat heater switch pack failure | 9 | Body |
| B1A52 | Driver's seat memory switches and motor actuators failure | 3 | Body |
| B1A53 | Driver's seat heater field effect transistor failure | 3 | Body |
| B1A54 | Occupant safety belt tension sensor | 3 | Body |
| B1A55 | Crash record output circuit | 3 | Body |
| B1A56 | FailURE BT INIT | 3 | Body |
| B1A57 | Left headlamp levelling motor | 3 | Body |
| B1A58 | Right headlamp levelling motor | 9 | Body |
| B1A59 | Sensor - 5 Volt Supply | 9 | Body |
| B1A60 | Failure LOC CRC | 3 | Body |
| B1A61 | Failure ECNR CRC | 3 | Body |
| B1A62 | Radio Broadcast Receiving Module (RBRM) DAB Antenna Circuit Open | 9 | Body |
| B1A63 | Radio Broadcast Receiving Module (RBRM) Audio Line-out Circuit Open | 3 | Body |
| B1AA0 | Infotainment Faceplate Enable Circuit Short to Ground | 4 | Body |
| B1AD1 | Audible Vehicle Alert Sound (AVAS) System Control Circuit Over Voltage | 7 | Body |
| B1AD2 | Audible Vehicle Alert Sound (AVAS) System Control Circuit Over Current | 1 | Body |
| B1AD3 | Pedestrian warning module thermal protection or short circuit protection or DC fault | 1 | Body |
| B1AD4 | Pedestrian Alert Speaker (PAS) Open Circuit | 1 | Body |
| B1AE0 | 360° Left Camera Video Signal Short to Battery | 7 | Body |
| B1AE1 | 360° Right Camera Video Signal Short to Battery | 1 | Body |
| B1AE2 | 360° Front Camera Video Signal Short to Battery | 1 | Body |
| B1AE3 | 360° Rear Camera Video Signal Short to Battery | 1 | Body |
| B1AE4 | Rear camera Video Signal Circuit Short to Battery | 1 | Body |
| B1AE8 | Camera video signal circuit short to power supply | 1 | Body |
| B1AE9 | Camera Power Short to Ground | 1 | Body |
| B1B00 | Front left probe not working properly | 11 | Body |
| B1B01 | Front right probe not working properly | 11 | Body |
| B1B04 | Left rear middle probe not working normally | 14 | Body |
| B1B05 | Rear right middle probe not working properly | 13 | Body |
| B1B06 | DR.ABG squib(2) open | 11 | Body |
| B1B20 | PIN not programmed | 7 | Body |
| B1B21 | ESK not programmed | 8 | Body |
| B1B40 | Main control initialization failed | 5 | Body |
| B1B41 | Left Front Outer Sensor Power Circuit | 5 | Body |
| B1B42 | Mode switching failed | 5 | Body |
| B1B43 | Left Rear Inner Sensor Power Circuit | 4 | Body |
| B1B44 | Temperature too low | 3 | Body |
| B1B45 | Right Rear Outer Sensor Power Circuit | 3 | Body |
| B1B46 | ACC relay internal fault | 4 | Body |
| B1B60 | Feedback potentiometer circuit | 5 | Body |
| B1B61 | Pollution sensor hydrocarbons (HC) input circuit | 4 | Body |
Some brand data is extracted from diagnostic files and may contain manufacturer-specific wording. General SAE J2012 descriptions are used where available.