Proton fault codes
8,866 codes · 50 vehicle records · 175 ECU records · 0 live-data parameters
Codes 8,866
| Code | Description | Brands | System |
|---|---|---|---|
| C1131 | Hood solenoid 2 - N341 | 22 | Chassis |
| C1132 | Hood solenoid 3 - N342 | 15 | Chassis |
| C1133 | Hydraulic pump - Timeout | 16 | Chassis |
| C1200 | Torque sensor power supply voltage failure | 30 | Chassis |
| C1201 | Motor circuit short to battery or ground | 30 | Chassis |
| C1202 | Current following abnormality | 29 | Chassis |
| C1204 | Motor current too low | 24 | Chassis |
| C1205 | Power supply voltage too high | 29 | Chassis |
| C1206 | Power supply voltage too low | 28 | Chassis |
| C1207 | Seat lumbar height switch - passenger's | 29 | Chassis |
| C1208 | Memory reading and writing error | 23 | Chassis |
| C120C | Torque sensor power supply is seriously abnormal | 15 | Chassis |
| C1210 | Fault - engine in running status | 29 | Chassis |
| C1211 | Attempt to restart assist at high speed | 29 | Chassis |
| C1212 | Vehicle speed signal not received | 26 | Chassis |
| C1215 | C1214/ Memory switch position 1/2 - passenger's | 21 | Chassis |
| C1216 | Memory switch position 3 - passenger's | 22 | Chassis |
| C1217 | Pump motor shorted to ground | 21 | Chassis |
| C1219 | Memory set switch - passenger's | 18 | Chassis |
| C121A | Close the routine. Turn off the key for 10 s and clear the DTC -54 | 7 | Chassis |
| C121C | Software configuration invalid | 10 | Chassis |
| C121D | Control Module Improper Shutdown | 10 | Chassis |
| C121E | RAM check error | 11 | Chassis |
| C1222 | Seat depth motor - passenger's | 26 | Chassis |
| C1223 | Seat depth sensor - passenger's | 22 | Chassis |
| C1225 | Speed control relay - passenger's | 25 | Chassis |
| C1226 | Excessive RF Wheel Acceleration | 25 | Chassis |
| C1231 | Control unit internal fault | 25 | Chassis |
| C1236 | Vehicle speed signal invalid | 27 | Chassis |
| C123A | If C2206, and/or C2202 are active then continue, else if any other ABS DTCs are active correct those first before continuing | 11 | Chassis |
| C123B | Electronic Brake Control Module RAM Program Overflow | 10 | Chassis |
| C123C | Electronic Brake Control Module RAM Malfunction | 8 | Chassis |
| C1240 | ABS received data invalid | 14 | Chassis |
| C1241 | FL outlet valve | 26 | Chassis |
| C1242 | Pump motor circuit open | 18 | Chassis |
| C1243 | Pump Motor Stalled (Solid state motor control only) | 10 | Chassis |
| C1244 | Longitudinal G sensor | 14 | Chassis |
| C1245 | Longitudinal G sensor | 16 | Chassis |
| C1246 | Rear Right sub loudspeaker | 26 | Chassis |
| C1248 | Differential lock SW open wire | 13 | Chassis |
| C1249 | Tyre Pressure Sensor - Front Left | 15 | Chassis |
| C124A | AWD Oil Pump Motor Speed Sensor Signal Circuit High Voltage | 11 | Chassis |
| C1250 | Tyre Pressure Sensor - Front Right | 19 | Chassis |
| C1251 | Tyre Pressure Sensor - Rear Left | 25 | Chassis |
| C1256 | Falla interna | 24 | Chassis |
| C1260 | Steering sensor - signal fault | 18 | Chassis |
| C1261 | LF hold valve solenoid | 27 | Chassis |
| C1266 | LR outlet valve solenoid | 26 | Chassis |
| C1270 | System information storage terminal not implemented | 13 | Chassis |
| C1271 | Left driven TCS isolation solenoid fault (ABS 5.3 only) | 21 | Chassis |
Some brand data is extracted from diagnostic files and may contain manufacturer-specific wording. General SAE J2012 descriptions are used where available.