Opel fault codes
15,060 codes · 16 vehicle records · 175 ECU records · 0 live-data parameters
Codes 15,060
| Code | Description | Brands | System |
|---|---|---|---|
| P1C8D | Power supply 1 circuit/open | 10 | Powertrain |
| P1C8F | Power supply 1 circuit high | 10 | Powertrain |
| P1C90 | Toiteahel 2/avatud | 9 | Powertrain |
| P1C92 | Mạch nguồn 2 cao | 10 | Powertrain |
| P1C98 | Växellägesgivare 1 krets låg | 8 | Powertrain |
| P1C9A | Starter/Generator Control Module Internal Current Out of Range | 7 | Powertrain |
| P1CA3 | Växellägegivare 4 krets hög | 10 | Powertrain |
| P1CB0 | Gear shift actuator 4 disengage failure | 12 | Powertrain |
| P1CB1 | Gear shift actuator 1 engage failure | 11 | Powertrain |
| P1CB3 | Gear shift actuator 3 engage failure | 10 | Powertrain |
| P1CB4 | Gear shift actuator 4 engage failure | 11 | Powertrain |
| P1CB5 | Actual Torque not Plausible | 10 | Powertrain |
| P1CB6 | Monitoring of Torque Comparison Check out of Range | 10 | Powertrain |
| P1CB7 | Stationary Damping Control out of Rang | 9 | Powertrain |
| P1CB8 | DCDC Voltage not Plausible | 8 | Powertrain |
| P1D11 | Motor overload fault | 16 | Powertrain |
| P1D12 | Bus overcurrent | 15 | Powertrain |
| P1D13 | Controller temperature sensor fault | 17 | Powertrain |
| P1D19 | Power module failure | 14 | Powertrain |
| P1D1B | VCU V2S Voltage Sensor Circuit High | 11 | Powertrain |
| P1D1C | Controller input voltage is lower than the lower limit | 11 | Powertrain |
| P1D1D | Controller input voltage is higher than the upper limit | 10 | Powertrain |
| P1D22 | Battery Charger Temperature Sensor Circuit Malfunction | 14 | Powertrain |
| P1D23 | Phase current sensor failure | 14 | Powertrain |
| P1D24 | Power circuit | 14 | Powertrain |
| P1D25 | Shift control rationality | 17 | Powertrain |
| P1D28 | Temperature in inverter circuit 1 | 14 | Powertrain |
| P1D29 | Pinge muundur 2 vooluring | 10 | Powertrain |
| P1D2C | Hydrogen tank pressure sensor circuit | 12 | Powertrain |
| P1D2E | Battery Condition Monitor Module Lost Communication With Gauge Control Module | 11 | Powertrain |
| P1D2F | Oil viscosity sensor overtemperature | 14 | Powertrain |
| P1D30 | This procedure deletes the DTC P1C5F and (Too low viscosity) immediately after the procedure has been performed. | 17 | Powertrain |
| P1D31 | ROM/RAM failure | 12 | Powertrain |
| P1D32 | EEPROM fail | 13 | Powertrain |
| P1D33 | AD converter abnormal | 12 | Powertrain |
| P1D34 | Gagal sensor arus input | 12 | Powertrain |
| P1D35 | Tulovirta-anturin vika | 11 | Powertrain |
| P1D36 | EV remotest signal abnormal | 13 | Powertrain |
| P1D37 | Internal control module software reset 2 active | 13 | Powertrain |
| P1D38 | Internal control module level 2 injection cut off active | 14 | Powertrain |
| P1D39 | Sinal IGCT-FDE anormal | 13 | Powertrain |
| P1D3A | Battery Condition Monitor Module EEPROM Error (FSA Operated) | 12 | Powertrain |
| P1D3B | Internal control module monitoring byte error | 13 | Powertrain |
| P1D3C | Stack coolant temperature sensor correlation | 13 | Powertrain |
| P1D3D | Internal control module serial link error | 12 | Powertrain |
| P1D3E | ECU iç izleme 1 | 13 | Powertrain |
| P1D3F | Internal control module shut off test undervoltage error | 12 | Powertrain |
| P1D40 | Suhu gegelung penyearah | 15 | Powertrain |
| P1D44 | Motor B phase current sampling circuit fault | 15 | Powertrain |
| P1D45 | Motor C phase current sampling circuit fault | 13 | Powertrain |
Some brand data is extracted from diagnostic files and may contain manufacturer-specific wording. General SAE J2012 descriptions are used where available.