Mazda fault codes
2,569 codes · 32 vehicle records · 9 ECU records · 0 live-data parameters
Codes 2,569
| Code | Description | Brands | System |
|---|---|---|---|
| B2498 | 39 = Warning light circuit failure | 10 | Body |
| B2900 | No description available | 5 | Body |
| B2909 | No description available | 6 | Body |
| B9843 | Estimate an Open Circuit fault (set DTC) if the open is detected on the input for greater than 60 seconds (at a one second sample rate) while speed is > 20 kpH/12.4 mpH, in the A4WD or 4LOW modes | 2 | Body |
| BBD1F | No description available | 1 | Body |
| BFAFE | No description available | 2 | Body |
| C0023 | Stop Lamp Control | 28 | Chassis |
| C0044 | Right Front Wheel Speed Sensor Circuit Intermittent | 28 | Chassis |
| C00DF | No description available | 2 | Chassis |
| C012B | High Pressure Accumulator Pressure Sensor | 8 | Chassis |
| C0167 | Longitudinal accelerometer bias fault | 7 | Chassis |
| C102D | High friction inside power steering | 7 | Chassis |
| C105B | RR outlet valve | 7 | Chassis |
| C1101 | Battery voltage high | 25 | Chassis |
| C1102 | Battery voltage low | 24 | Chassis |
| C1106 | Tire Size Mismatch | 19 | Chassis |
| C1110 | Power steering calibration data | 22 | Chassis |
| C1117 | Convertible top front latch | 18 | Chassis |
| C1148 | Left Park Brake Actuator Circuit | 13 | Chassis |
| C1233 | Seat height adjustment sensor - passenger's | 17 | Chassis |
| C1235 | Seat forward/rearward sensor - driver's | 19 | Chassis |
| C1236 | Vehicle speed signal invalid | 27 | Chassis |
| C1237 | This test guides the operator with setting the sensitivity of the microwave sensors and C1238 | 17 | Chassis |
| C1250 | Tyre Pressure Sensor - Front Right | 19 | Chassis |
| C1254 | EPS ECU internal fault (related to APA) | 17 | Chassis |
| C1259 | Steering sensor - electrical fault | 16 | Chassis |
| C1260 | Steering sensor - signal fault | 18 | Chassis |
| C1261 | LF hold valve solenoid | 27 | Chassis |
| C1265 | LR hold valve solenoid | 15 | Chassis |
| C1266 | LR outlet valve solenoid | 26 | Chassis |
| C1267 | can be generated by the antilock brake module | 15 | Chassis |
| C1400 | Abnormal reset performed by HW | 19 | Chassis |
| C1445 | control. Clear DTC(Diagnostic Trouble Codes) after normal operation is restored | 12 | Chassis |
| C1475 | No description available | 6 | Chassis |
| C1680 | DTC(Diagnostic Trouble Codes): are not currently stored | 6 | Chassis |
| C1700 | Ground connection X13542 | 15 | Chassis |
| C1701 | 1F = Turn Lamp Circuit Fault | 13 | Chassis |
| C1702 | Ground connection X13542 | 14 | Chassis |
| C1703 | Internal fault of left front sensor | 14 | Chassis |
| C1704 | Left front center sensor internal fault | 16 | Chassis |
| C1705 | Right front center sensor internal fault | 16 | Chassis |
| C1731 | CAN Invalid Data From Steering Angle Sensor | 9 | Chassis |
| C1733 | Cruise Control Disabled from HCU DTC not stored | 10 | Chassis |
| C1736 | Compressor relay short to gnd/open CKT | 9 | Chassis |
| C1738 | Exhaust Solenoid Valve Short To GND | 9 | Chassis |
| C1750 | Left Front Tire Pressure Sensor Detector | 11 | Chassis |
| C1751 | Right Front Tire Pressure Sensor Detector | 13 | Chassis |
| C1800 | The 4WAS/2WAS Module shall log DTC when it determines that a fault exists in the output circuit for the relay that controls air flow to and from the Reservoir | 11 | Chassis |
| C1805 | Hydraulic support fault | 10 | Chassis |
| C1850 | No description available | 5 | Chassis |
Some brand data is extracted from diagnostic files and may contain manufacturer-specific wording. General SAE J2012 descriptions are used where available.