Hyundai fault codes
7,974 codes · 345 vehicle records · 168 ECU records · 0 live-data parameters
Codes 7,974
| Code | Description | Brands | System |
|---|---|---|---|
| C1265 | LR hold valve solenoid | 15 | Chassis |
| C1266 | LR outlet valve solenoid | 26 | Chassis |
| C1267 | can be generated by the antilock brake module | 15 | Chassis |
| C1268 | L4 signal detection abnormal | 11 | Chassis |
| C1269 | R signal line abnormal | 10 | Chassis |
| C1270 | System information storage terminal not implemented | 13 | Chassis |
| C1271 | Left driven TCS isolation solenoid fault (ABS 5.3 only) | 21 | Chassis |
| C1272 | Engine speed signal not received | 13 | Chassis |
| C1273 | Right driven TCS isolation solenoid fault (ABS 5.3 only) | 23 | Chassis |
| C1274 | Right driven TCS solenoid fault (DBC7 only) | 24 | Chassis |
| C1275 | Not perform: ESP Not control, DTC display | 16 | Chassis |
| C1276 | Défaut signal couple fourni | 24 | Chassis |
| C1277 | Falla Señal de Par Solictado | 14 | Chassis |
| C1278 | TCS temporarily inhibited by PCM | 24 | Chassis |
| C1279 | Valve power circuit stuck on | 22 | Chassis |
| C1280 | Motor fail safe relay | 21 | Chassis |
| C1281 | Motor fail safe relay | 21 | Chassis |
| C1282 | Motor fail safe relay | 21 | Chassis |
| C1283 | Lateral acceleration sensor - signal fault | 15 | Chassis |
| C128308 | The SCC Module sets DTC when it received abnormal YAW rate sensor CAN message from ESP(ESC) via CAN | 1 | Chassis |
| C128386 | If the yaw rate and horizontal acceleration signals are not received via CAN lines, the LKAS module generates the fault code and turns on the Malfunction Indicator Lamp | 1 | Chassis |
| C128387 | DTC for detected torque sensor 2 problems. | 2 | Chassis |
| C1284 | Front centre tweeter loudspeaker | 14 | Chassis |
| C1285 | Rear left bass loudspeaker | 15 | Chassis |
| C128504 | If yaw rate(Ax) sensor is not calibrated, HECU sets DTC | 1 | Chassis |
| C1286 | Stroke sensor 0 point voltage abnormal | 14 | Chassis |
| C128602 | If internal fault on ACU or IMU is detected, HECU sets DTC.※ IMU: Yaw rate & G sensor integrated ACU | 1 | Chassis |
| C1287 | Rear left treble loudspeaker | 14 | Chassis |
| C1290 | Main torque signal failure | 22 | Chassis |
| C1291 | Auxiliary torque signal failure | 23 | Chassis |
| C1292 | Main and auxiliary torque signal sum faults | 23 | Chassis |
| C1293 | Audio amplifier | 16 | Chassis |
| C1294 | DAB antenna | 17 | Chassis |
| C1300 | Brake pressure sensor failure | 28 | Chassis |
| C1301 | Brake pressure sensor failure | 21 | Chassis |
| C1306 | Longitudinal acceleration sensor signal fault | 17 | Chassis |
| C1310 | Automatic emergency braking (AEB) signal interference | 24 | Chassis |
| C1312 | Automatic Emergency Braking (AEB) temperature is outside operating temperature range | 17 | Chassis |
| C1313 | Voltage out of range | 17 | Chassis |
| C1314 | Controller supply voltage low | 16 | Chassis |
| C1315 | Lateral acceleration sensor signal fault | 23 | Chassis |
| C1316 | Lateral acceleration sensor signal fault | 17 | Chassis |
| C1317 | Gyro acceleration sensor signal failure | 15 | Chassis |
| C1318 | Motor current too large | 13 | Chassis |
| C1319 | Motor current too small | 12 | Chassis |
| C1320 | Left front wheel speed sensor signal failure | 18 | Chassis |
| C1321 | Left front wheel speed sensor signal failure | 21 | Chassis |
| C1322 | Left front wheel speed sensor fault | 21 | Chassis |
| C1323 | Falla del Circuito Par Entregado del PCM al EBTCM | 12 | Chassis |
| C1324 | Panne du circuit actif EBTCM PCM/TCS | 12 | Chassis |
Some brand data is extracted from diagnostic files and may contain manufacturer-specific wording. General SAE J2012 descriptions are used where available.