DENZA fault codes
Coverage shown is BYD data: 7,677 codes · 97 vehicle records · 71 ECU records · 0 live-data parameters.
DENZA shares fault-code data with BYD. Data may not cover DENZA-specific systems.
Codes 7,677
| Code | Description | Brands | System |
|---|---|---|---|
| P1688 | W11 engine: Fault code stored | 26 | Powertrain |
| P1689 | Engine Control Module | 21 | Powertrain |
| P168A | Level 3 too high | 15 | Powertrain |
| P168B | Level 3 too low | 12 | Powertrain |
| P168C | Turbocharger vane position slow response - increasing position | 12 | Powertrain |
| P168D | Turbocharger vane position slow response - decreasing position | 12 | Powertrain |
| P168E | Fuel injector control module not programmed | 13 | Powertrain |
| P1700 | Transmission control module (TCM) requested SVS illumination | 30 | Powertrain |
| P1701 | Reverse engagement error | 33 | Powertrain |
| P1702 | Transmission clutch 1 stuck on | 29 | Powertrain |
| P1703 | Brake switch out of self-test range | 31 | Powertrain |
| P1704 | Transmission clutch 1 slip detected | 30 | Powertrain |
| P1705 | Throttle Position Sensor (TPS) - A/T | 37 | Powertrain |
| P1706 | High vehicle speed observed in park | 33 | Powertrain |
| P1707 | SMG: Safety concept, level 2, gearbox | 29 | Powertrain |
| P1708 | SMG: Safety concept, level 2, clutch | 22 | Powertrain |
| P1709 | SMG: Safety concept, level 3 | 24 | Powertrain |
| P170A | Clutch switch out of self-test range | 20 | Powertrain |
| P170B | Clutch Adaptive Learning Not Done - Incorrect Engine Conditions | 17 | Powertrain |
| P170C | Clutch A Engagement Time Performance | 15 | Powertrain |
| P170D | Clutch B Engagement Time Performance | 15 | Powertrain |
| P170E | Park Pawl Motor Power Relay Circuit High | 13 | Powertrain |
| P170F | Clutch pressure release valve failed | 15 | Powertrain |
| P1710 | Sensor power failure | 31 | Powertrain |
| P1711 | Wheel speed signal 1 range/performance | 27 | Powertrain |
| P1712 | Front right wheel speed sensor signal malfunction (CAN) | 25 | Powertrain |
| P1713 | TFT Sensor In Range Failure Low Value | 24 | Powertrain |
| P1714 | Shift solenoid A inductive signature | 22 | Powertrain |
| P1715 | SMG: Hydraulic pressure loss in system | 34 | Powertrain |
| P1716 | SMG: Switch-on frequency, hydraulic unit | 30 | Powertrain |
| P1717 | SMG: ON period, hydraulic unit | 19 | Powertrain |
| P1718 | Incorrect neutral gear ratio | 20 | Powertrain |
| P1719 | Engine Torque Signal | 20 | Powertrain |
| P171A | Transmission surge solenoid valve circuit open | 16 | Powertrain |
| P171B | Transmission surge solenoid valve circuit low | 13 | Powertrain |
| P171C | Transmission surge solenoid valve circuit high | 15 | Powertrain |
| P171D | Ignition key withdrawal lock electrical fault | 13 | Powertrain |
| P171E | Shift Fork C Stuck_ Movement On Shift Fork A | 13 | Powertrain |
| P171F | Park Pawl System Stack Malfunction after Learning Mode | 12 | Powertrain |
| P1720 | SMG: CAN bus error | 36 | Powertrain |
| P1721 | Gear 1 incorrect ratio | 27 | Powertrain |
| P1722 | Gearbox output speed 2 implausible signal | 25 | Powertrain |
| P1723 | Starter interlock signal: open circuit | 25 | Powertrain |
| P1724 | Gear 4 incorrect ratio | 22 | Powertrain |
| P1725 | Insufficient engine speed increase during self-test | 27 | Powertrain |
| P1726 | Wheel speed signal 4 range/performance | 27 | Powertrain |
| P1727 | Shift motor electric | 22 | Powertrain |
| P1728 | Shift motor mechanic | 27 | Powertrain |
| P1729 | Select motor electric | 20 | Powertrain |
| P172A | Output speed sensor direction not plausible - forward | 17 | Powertrain |
Some brand data is extracted from diagnostic files and may contain manufacturer-specific wording. General SAE J2012 descriptions are used where available.